Multi scene setup

[Bharat Sharma]

Hello,

 

gts Turing unity terrain black whenever I apply profile to a streamed terrain (6×6 tile size 512, multi scene setup), alpine biome, unity 2021.3.15 (hdrp).

 

Thanks

[Isaac]

Hi @Bharat Sharma,

Try locating the folder where your GTS scene data is stored. This can be found through selecting any of the loaded terrains, clicking on the Material section, then going up one folder of where that is located:

Then going up one more level, finding these folders: 

You can safely delete all of these folders, then hit apply profile again.

Next time you save it should regenerate the necessary data. 

[Bharat Sharma]

On 1/4/2023 at 8:43 AM, Isaac said:

Hi @Bharat Sharma,

Try locating the folder where your GTS scene data is stored. This can be found through selecting any of the loaded terrains, clicking on the Material section, then going up one folder of where that is located:

Then going up one more level, finding these folders: 

You can safely delete all of these folders, then hit apply profile again.

Next time you save it should regenerate the necessary data. 

 

Hello, I'm using gaia inbuilt streaming and that did not fix the problem, can please check it. 

[Isaac]

Hi, could you please send a screenshot of what the terrain looks like when the profile is applied?

[Bharat Sharma]

Hello

 

Error does not appeared in the new project so far, but what happened is some time applying gts profile turns some textures to go pitch black. Same if apply more then 8 textures to unity terrain.

 

I will post it with screenshot if it happens again.

On 1/16/2023 at 3:37 AM, Isaac said:

Hi, could you please send a screenshot of what the terrain looks like when the profile is applied?

 

[Bryan]

Sounds good please let us know 

 

[Bharat Sharma]

On 1/16/2023 at 3:37 AM, Isaac said:

Hi, could you please send a screenshot of what the terrain looks like when the profile is applied?

@Isaac @Bryan this is what happens when I use multi-scene workflow with gts, as you can see in the screenshot the black spots or patches.  This happens after I split the terrain.

[Isaac]

Hi @Bharat Sharma, can you check in the material if there is Weight Splat Index texture assigned to the material? You can refer to the above post to find where to navigate the terrain's material.

Also, can you check where the referenced Control textures point to - check if the control textures are located in the same folder as the terrain material.