GeNa Pro - Roads per Point Width

[SkullAndSmile]

Good Day, 

I have a question. I would for my road to get less wide between certain points. But it seems like the editing is always for the whole spline. Did I miss anything? 

 

Sincerely,
Felix Schmidt

[Bryan]

You can try this: 
Enable the Use Sloped Cross Section:


Then you can adjust the Height Transition in the road profile settings in the Road Extension: 

 

[Bryan]

Or you can simply change the Road Width: 

[SkullAndSmile]

I know about the Road Width value as shown in my image, but🙂 I would like to edit the road width specific to certain points. When I edit the Road Width, it changes for the entire road and not for a specific point. Is there a way to edit this value for a certain point? 

[Bryan]

On 7/28/2022 at 8:53 PM, SkullAndSmile said:

I know about the Road Width value as shown in my image, but🙂 I would like to edit the road width specific to certain points. When I edit the Road Width, it changes for the entire road and not for a specific point. Is there a way to edit this value for a certain point? 

Oh sadly no not at this time. 

[SkullAndSmile]

Okay, 🙂 It's luckily not too important, I can work with my cave to make the road a bit smaller. 

 

Thanks for your time and response.